So, I've built the bike I wanted and I have a few spares left over.
Here are a pair of standard camshafts, around 14,000 miles on them. Looking for £120 ono plus P&P.
Thanks for looking,
DJ
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
GPz1100A1 - Standard Camshafts - SOLD
Moderators: paul doran, Taffus, KeithZ1R, chrisu
GPz1100A1 - Standard Camshafts - SOLD
Last edited by Ragster on Sat Feb 18, 2023 6:33 pm, edited 1 time in total.
Re: GPz1100A1 - Standard Camshafts
Helo Dave, are these 'reduced' base circle? The reason i ask is Unitrak 1100 cams are usually about 9.5 to 9.6 mm lift!
AL
AL
1981 J1
Re: GPz1100A1 - Standard Camshafts
Al wrote:Helo Dave, are these 'reduced' base circle? The reason i ask is Unitrak 1100 cams are usually about 9.5 to 9.6 mm lift!
AL
All my Uni cams are dead on 9.7 and no grooves on either blank tacho drive boss.
Doubt that these are reduced base though.
It's not needed until you get to around .480" - 12mm lift..
Re: GPz1100A1 - Standard Camshafts
Hi, ignore the writing on the lobes, can’t remember what that was in relation to, but these are standard @9.70mm lift.
Thanks,
DJ
Thanks,
DJ
Re: GPz1100A1 - Standard Camshafts
PM'd you.
'In your twenties you think you are immortal, in your thirties you hope you are immortal, in your forties you just hope it doesn't hurt too much'
Lemmy
Lemmy
Who is online
Users browsing this forum: No registered users and 17 guests