gudgeon pin diameter

stubby · #1 PostAuthor: **stubby** » Fri Jul 22, 2011 1:36 pm

what is the pin diameter in the stock z1000 motor.
thanks in advance..

kev edwards · #2 PostAuthor: **kev edwards** » Fri Jul 22, 2011 2:24 pm

Hi Stubby, it is 16.997mm with a wear limit of 16.96mm in inches it is 0.669" with a wear limit of 0.668".

#3 PostAuthor: **Ginger Bear** » Fri Jul 22, 2011 3:25 pm

Bloody hell Kev, that's a very comprehensive answer :bow

..... I'd have just said 17mm. :up

kev edwards · #4 PostAuthor: **kev edwards** » Fri Jul 22, 2011 7:45 pm

Ginger Bear wrote:Bloody hell Kev, that's a very comprehensive answer ..... I'd have just said 17mm.

Steve, pitfalls of working in an industry where every micron counts, hopefully it do'nt make me an annorak. :roll:

#5 PostAuthor: **Ginger Bear** » Fri Jul 22, 2011 9:08 pm

Not at all Kev..... Good to have some spot on accurate advice.