I have checked z1 enterprises and thay have the same body as vm26.But the mixture screw is under the float bowl not in the side as thiers shows.
Thanks David
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
What are these carbs ?ALL SORTED THANKS
Moderators: chrisu, paul doran, Taffus, KeithZ1R
What are these carbs ?ALL SORTED THANKS
Does any one know what carbs these are
I have checked z1 enterprises and thay have the same body as vm26.But the mixture screw is under the float bowl not in the side as thiers shows.
Thanks David
I have checked z1 enterprises and thay have the same body as vm26.But the mixture screw is under the float bowl not in the side as thiers shows.
Thanks David
Last edited by zman on Thu Mar 08, 2012 3:08 pm, edited 1 time in total.
keep thoses wheels turning
99.9% likely to be z1000a with the two fuel pipes, could also be Gs1000 but they usually have one central fuel pipe as per the later z1000 28's .
Last edited by zed1015 on Thu Mar 08, 2012 9:23 am, edited 1 time in total.
Zman those carbs are Mikuni 26 mm off a 77 Z1000A1.
Show me the throat closest to the engine and we will be able to tell if they are possibly 28mm.
That mixture screw performs the same function as the usual air screws on the side, however, this screw controls the fuel, rather than controlling the air.
"High-top" Mikunis of this era all had that option built into the die-casting.
RegardZ.
Show me the throat closest to the engine and we will be able to tell if they are possibly 28mm.
That mixture screw performs the same function as the usual air screws on the side, however, this screw controls the fuel, rather than controlling the air.
"High-top" Mikunis of this era all had that option built into the die-casting.
RegardZ.
Garn (Sydney) Z1, Z1A, Z1B and Z900-A4
http://www.ebay.co.uk/itm/260962878805? ... 1439.l2649
Think these are the same 26mm
Think these are the same 26mm
Who is online
Users browsing this forum: No registered users and 45 guests