Looking at these pix anyone know which is the correct bit and which the interloper?
If it's the winding I can probably get a new one from electrex world, but there's no point until I know which IS the villain of the peace!
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Z1100 shaft Alternator
Moderators: chrisu, paul doran, Taffus, KeithZ1R
-
RALPHARAMA
- Area Rep.
- Posts: 2752
- Joined: 19th May 2007
- Location: Pensford, Somerset
- Contact:
Z1100 shaft Alternator
As I mentioned in the project thread; I have either the wrong windings or the wrong rotor on my Z1100shaft motor,
Looking at these pix anyone know which is the correct bit and which the interloper?
If it's the winding I can probably get a new one from electrex world, but there's no point until I know which IS the villain of the peace!
Looking at these pix anyone know which is the correct bit and which the interloper?
If it's the winding I can probably get a new one from electrex world, but there's no point until I know which IS the villain of the peace!
Ralph Ferrand
Z1000A1 (1977), Godier Genoud Z1300A5 (1983), Z900A4 Stock (1976), Z900A4 Special (project), GPZ1100 Unitrak (1983), ZRX1200R (2004) DT175MX (1981).
http://www.bikerstoolbox.co.uk
Don't be caught out http://www.dhlparcels.info/
Z1000A1 (1977), Godier Genoud Z1300A5 (1983), Z900A4 Stock (1976), Z900A4 Special (project), GPZ1100 Unitrak (1983), ZRX1200R (2004) DT175MX (1981).
http://www.bikerstoolbox.co.uk
Don't be caught out http://www.dhlparcels.info/
-
Timothy Comerford
- Regular Poster
- Posts: 58
- Joined: 26th Jun 2011
- Location: Dublin Ireland
Rotor.
Hi Ralph
I had some problems with the rotor on my "Septic" as Paul D calls it. Some of the magnets had broken and come detached from the metal rotor . I replaced the whole rotor with an Electrex unit at a cost of approx £140.
The diameter of the old one was 5inches from outside to outside. As I havent mastered the art of Phopo Bucket , I will ask Paul to post some pix.
Well done on the re build Ralph, I have followed with great intrest.
Tim.
I had some problems with the rotor on my "Septic" as Paul D calls it. Some of the magnets had broken and come detached from the metal rotor . I replaced the whole rotor with an Electrex unit at a cost of approx £140.
The diameter of the old one was 5inches from outside to outside. As I havent mastered the art of Phopo Bucket , I will ask Paul to post some pix.
Well done on the re build Ralph, I have followed with great intrest.
Tim.
"By far the best proof is experience"
-
Ginger Bear
- Hardcore
- Posts: 5512
- Joined: 16th Dec 2008
- Location: In the Dark.
- Contact:
Who is online
Users browsing this forum: No registered users and 50 guests