Got the frame primed
But had to wait ages to do the gloss black as it was too cold in the garage to get a decent finish
Didn't turn out too bad for a rattle can job.
Managed to get a bit further along today with the reassembly
Scratched my head a bit trying to remember where all the wiring went
Finally finished fitting the AFAM 530 chain & sprocket conversion after problems with the chain rubbing on the engine casing (Spacer added after useful advise from Z1ParR) - by the way that's a piece of cotton & not a scratch in the picture above - had a slight panic when I uploaded the pictures - had to go & check what it was LOL
Hoping to do a bit more tomorrow










