Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Metal bodied oil seals
Moderators: chrisu, paul doran, Taffus, KeithZ1R
Metal bodied oil seals
After trying to fit the 3 metal bodied oil seals (see pic) to the transmission covers with finger pressure, and then tapping them with a wooden drift, unsuccessfully, I discovered they're quite a tight fit. Can they be pressed in using the old threaded rod/washers/nuts trick or is heating the cases the way to go, or a combination of the two? Slightly worried that the cases will get damaged with too much pressure as they look a bit fragile.
- Attachments
-
Z1-B, 360bhp ZX1000NGF
90% of questions that begin "Why..." can be answered with "Because people are stupid."
90% of questions that begin "Why..." can be answered with "Because people are stupid."
Re: Metal bodied oil seals
just tap them in with a hammer as long as use tap them in square they will be fine
Who is online
Users browsing this forum: zed9 and 33 guests