Hi guys
I have just noticed on No. 4 carb,one of the overflow tubes has cracked inside the chamber where it enters the casting, are these tubes available from anywhere or is it a new chamber required, unfortunately it is off a set of pumper carbs so is slightly different
Cheers
Gavin
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Z1000 float chamber issue
Moderators: chrisu, paul doran, Taffus, KeithZ1R
Z1000 float chamber issue
Z1000 MK2
Z1300 DFI
Z1300 DFI
Re: Z1000 float chamber issue
clean it up, and solder the crack 
Keith
You can never have too many tools in your life, except the two legged variety
I'm never wrong, once I thought I was but I was
mistaken.
Phil Churchett winner 2013
You can never have too many tools in your life, except the two legged variety
I'm never wrong, once I thought I was but I was
mistaken.
Phil Churchett winner 2013
Re: Z1000 float chamber issue
KeithZ1R wrote:clean it up, and solder the crack
What he said, if they're brass they should solder.
ʎɐqǝ uo pɹɐoqʎǝʞ ɐ ʎnq ı ǝɯıʇ ʇsɐן ǝɥʇ sı sıɥʇ
Re: Z1000 float chamber issue
Cheers Keith & Garry,
It was cracked just below the point it enters the aluminium body, had a couple of tries with no success then decided the open the crack up a little and put lots of solder in, then drilled the tube clear of solder,
Jobs a good un it doesn’t leak.
It was cracked just below the point it enters the aluminium body, had a couple of tries with no success then decided the open the crack up a little and put lots of solder in, then drilled the tube clear of solder,
Jobs a good un it doesn’t leak.
Z1000 MK2
Z1300 DFI
Z1300 DFI
Who is online
Users browsing this forum: No registered users and 108 guests