GPz1100A1 - Standard Camshafts - SOLD

[Ragster]

So, I've built the bike I wanted and I have a few spares left over.

Here are a pair of standard camshafts, around 14,000 miles on them. Looking for £120 ono plus P&P.



Thanks for looking,
DJ

[Al]

Helo Dave, are these 'reduced' base circle? The reason i ask is Unitrak 1100 cams are usually about 9.5 to 9.6 mm lift!

AL

[zed1015]

Helo Dave, are these 'reduced' base circle? The reason i ask is Unitrak 1100 cams are usually about 9.5 to 9.6 mm lift!

AL

All my Uni cams are dead on 9.7 and no grooves on either blank tacho drive boss.
Doubt that these are reduced base though.
It's not needed until you get to around .480" - 12mm lift..

[Ragster]

Hi, ignore the writing on the lobes, can’t remember what that was in relation to, but these are standard @9.70mm lift.

Thanks,
DJ

[Mr Bump]

PM'd you.