Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Z1 Advancer
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Z1 Advancer
Anyone got the later advancer unit that will fit the early Z1 having some issues and want to cover all bases. It’s the one that has the advance timing marks. Thanks
Re: Z1 Advancer
Full advance on the early atd is the middle of the bob weight pivot to the right of the timing marks.
If that helps.
If this is a DYNA' S' timing problem you need the correct 3A stamped rotor for the early advancer otherwise you run out adjustment on the backplate slots.
If that helps.
If this is a DYNA' S' timing problem you need the correct 3A stamped rotor for the early advancer otherwise you run out adjustment on the backplate slots.
Re: Z1 Advancer
Cheers Rob, yes I have done this on the advice from Neil but I am slowly running out of things to test and replace so my last thing I can do is change inlet rubbers and open up the valve clearances. Then I am clutching at straws. Hence the advance, sure timing is right or at least close enough. Cheers Paul
Who is online
Users browsing this forum: No registered users and 36 guests